Dry Lubrication Plunger Pellets for Diecasting Shot Sleeve And Plunger

High-quality punch lubrication particles, large quantities are preferred.

Product description: Punch lubrication particles. The particle sizes of the product are divided into Φ1.0-1.5mm and Φ1.5-2.0mm. They melt at the top of the injection chamber and the injection head, and form a lubricating film in the injection chamber through the capillary effect. . Ease of use eliminates the need for drop-pump spray systems used with traditional oil- or water-based products.

Advantage:

1. No pollution caused by general oily lubricants

2. Reduce the occurrence of porosity in castings

3. It can extend the service life of the injection chamber and reduce the adverse effects caused by friction.

4. Extend the service life of the injection head

5. The particles are completely consumed during casting, and there is no pollution from lubricating oil.

6. There are no oil marks on the surface of the die-casting parts, and the surface is clean and bright.

7. When the sprue, runner, and soup cake are recycled and reused, there will be no oil stains, no smoke, and no air pollution.

8. The usage is very economical and can save money.

9. Keep the factory building, ceiling and floor clean and comply with current green requirements

Instructions for use

Use a particle transmitter to add particles into the pouring chamber. The amount used depends on the weight of the casting and must be tried through experience.

Reference values for different punch diameters

60mm 1-3g; 80mm 3-5g; 100mm 5-7g; 140mm 7-10g; >150mm 15-20g

Packaging: 25kg woven bag, 25KG paper drum

Shelf life: 24 months