Photovoltaic bracket 2-meter telephone

The global energy has promoted the rapid development of the new energy industry, and solar energy is an important basic energy among various renewable energy sources; Therefore, as a solar power generation technology that converts solar radiation into electricity, the photovoltaic industry is developing rapidly.

There are also various processing methods for photovoltaic brackets, among which the section steel is made of steel plates with different thicknesses. According to the design requirements, the steel is processed and formed in the factory. This forming method can be calculated based on the stress of different structural parts of the photovoltaic engineering project, and different thicknesses of steel plates are used in different parts. Compared to hot-rolled one-time formed products, the stress is more reasonable, more suitable for on-site installation, and can also save steel.

The column photovoltaic support system is a small energy-saving photovoltaic module system suitable for use in fields such as solar water pumps and traffic monitoring. The component specifications used in the pillar system are small to medium-sized, so the design of the pillar system is simple and the structure is precise. The column system uses stainless steel circular pipes as the main load-bearing members; The supporting components of this support system include columns, main frame beams, support beams, guide rails, guide rail connection blocks, angle adjustment rods, side pressure, medium pressure, etc; In addition, the column system is fastened by standard stainless steel screws with 2-3 types of screws, so only 2-3 types of tools are needed for installation. In order to facilitate the installation and use of our customers, the components of our column system configuration are highly pre assembled as a complete set of components before shipment. Once received, customers can directly install them without the need for additional secondary processing.

At present, there are more and more restricted conditions for the use of solar photovoltaic brackets. The main reason is that the quality of steel is uneven, and installation requires a large amount of on-site drilling. However, the steel after drilling is prone to corrosion, so new brackets are needed to replace these angle steel brackets in order to slow down corrosion and extend service life.

Hebei photovoltaic bracket manufacturer, a new type of solar bracket main structure, with a special-shaped cold-formed thin-walled steel bracket structural system. Specially shaped cold-formed thin-walled steel is a prefabricated lightweight steel structural system that is mass-produced, rapidly assembled, and fully operational. It has the characteristics of low steel consumption, time-saving construction, and labor-saving.

The steel structure support of the special-shaped cold-formed thin-walled steel structure system is formed by connecting the prefabricated cold-formed thin-walled steel in the factory with bolts at the construction site to form a structural framework, and then installing battery panels to form an overall photovoltaic array.

Factory prefabricated integrated steel support system. Photovoltaic support manufacturers prefabricate steel structural frames with purlins. At the construction site, only the support modules need to be assembled and fixed on site, and then the battery panels are installed to form the entire photovoltaic array. The construction speed is fast, and it is suitable for large-scale power plants. The installation requirements for this type of steel structure bracket are high, and generally the steel used is of good quality and has a good surface treatment process.

There are two common and commonly used methods for installing the base of solar photovoltaic brackets, one is concrete based photovoltaic brackets, and the other is pile based photovoltaic brackets. Currently, some large photovoltaic power plants in China mostly use concrete for two reasons: firstly, the local geographical environment, and secondly, the consideration of cost control. However, a common type of photovoltaic bracket in foreign countries is the foundation of the pile.

Enterprise philosophy: survival based on quality, development based on reputation

Corporate spirit: Brave to explore and innovate, constantly surpassing oneself

Enterprise goal: Quality achievement, creating value, integrity is the foundation of the enterprise!