Juyu 304 liquid stirring tank, electric heating, double layer, single layer stirring bucket, stainless steel vacuum reactor

Electric heating mixing tankPurpose:

The electric heating mixing tank has the advantages of high temperature resistance, suitability for continuous batching, strong production capacity, and no need for steam heating, and is widely used in industrial departments such as medicine, beverages, chemicals, resins, and scientific research.

Structure:

It is composed of the pot body, pot cover, mixer, heating jacket, support and transmission device, shaft sealing device, etc. Composed of pot body, pot cover, mixer, shaft seal, electric heating device, etc. Made of stainless steel. The pot body is connected to the pot cover, with a discharge hole in the lower part of the pot body, a stirrer in the heating tank, and process pipe holes for feeding and temperature measurement are opened on the pot cover. The upper part of the pot cover is welded onto a bracket, equipped with a reducer and motor. The mixer inside the pot is driven by a transmission shaft, and the shaft seal device is located on the top of the pot cover. The heating jacket is equipped with inlet and outlet ports, vent ports, electric heating rods, and other connecting holes.

Usage and Maintenance:

1. The equipment should be inspected and lubricated before use in each shift to avoid dry grinding and damage to the equipment.

2. Connect the discharge port according to the production process requirements of your unit's products, and then check whether the electrical circuits are intact, whether the connections are safe and secure, and whether the fuses match. Only after everything is complete and correct can electric heating be turned on.

3. Before starting the machine, check the amount of heat transfer oil added. (The amount of oil added should be based on filling the oil inlet and then draining 5 liters of heat transfer oil. When adding oil, there should be a intermittent pause to allow air to be discharged from the interlayer.) The type of oil is 320 # high-quality heat transfer oil.

4. During normal use, the inlet oil tank on the upper edge of the pot should not be blocked after adding oil, and should be heated open for use. After daily operation, the electric heating power must be turned off.

5. Operators should not operate with water during operation. When there is oil leakage from the outside, stop the operation.

6. Strictly control the temperature during operation, usually around 200 degrees Celsius.

7. The interval between oil changes is about 12 months, and the oil can also be changed when the heating effect is not obvious when it is frequently used.

8. Conduct maintenance every 2 months, including checking the electric heating pipe, gaskets and circuit of each part, and verifying the temperature gauge.

9. This electric heating tank is a high energy consuming electrical equipment. In actual use,

It is necessary to ensure safe operation and management, strictly implement according to regulations, and keep daily operation records for better equipment maintenance.

10. When using a heating tank, it is necessary to first add the solution of the material, then input the material, start the mixer, and then turn on the electric heating power to reach the required temperature for the process. Before discharging, the electric heating power should be turned off first. After 2 to 10 minutes, the mixer should be turned off again. After processing, the heating tank should be rinsed with warm water as soon as possible to brush off the sticky materials. Then, the inner wall of the container should be thoroughly cleaned with alkaline water at 40 to 50 ℃, and washed with clean water. Special attention should be paid to not turning on the electric heating power when there are no materials (heat absorbing medium) in the pot and the pot is empty. Special attention should be paid to the use temperature, which should not exceed the rated working temperature of 220 ℃.