Fire water tank electronic level gauge static pressure cable input type level transmitter UHF-LT

The specialized liquid level display for fire protection adopts AI intelligent remote transmission, and the liquid level signal can be transmitted for 5000 meters, which is an important component of intelligent fire protection. There is no need for traditional manual labor to run upstairs and downstairs, greatly saving users' labor costs.
The electronic level gauge for the fire water tank is based on the principle that the static pressure of the measured liquid is proportional to the height of the liquid. It uses an advanced isolation type diffusion silicon sensor to convert the static pressure into an electrical signal, which is then converted into a standard electrical signal (such as 4-20mA) through temperature compensation and linear correction. It is equipped with a display controller to display and control the real-time water level on site.

The electronic liquid level gauge for the fire water tank consists of two parts: a liquid level probe and a display controller. The liquid level probe is composed of a stainless steel probe and a rubber gas conducting cable. The water level controller is composed of a display screen, setting buttons, and upper and lower limit control contact outputs. The tested water tank must be open to the atmosphere. If the medium is corrosive and high temperature, corresponding probes can be selected. When installing, the probe should be slowly placed towards the bottom of the water tank, and then the rubber gas conducting cable can be fixed at will, Then connect the ordinary wire to the control room controller, set the upper and lower limits on the water level controller, and connect the 220V mains power to complete the installation,