Jiahang PLC Control Laminated Filter Industrial Water 3-inch Fully Automatic Laminated Filter

The filter element of a laminated filter is a carrier for impurity treatment. It is composed of a group of plastic discs with grooves in different directions on both sides, which are stacked together. The groove edges on adjacent surfaces form numerous intersections, which form a large number of cavities and irregular paths, constantly shrinking from the outside to the inside. During filtration, these pathways cause turbulence in the water, ultimately causing impurities in the water to be intercepted at various intersections. If the discs are stacked and installed on the filter element framework, a filtering unit with loose outer and tight inner parts is formed under the pressure of the spring and water inlet. The laminations compressed by springs and water pressure in each filtering unit form a filter screen that cannot pass through countless impurities. The lamination width is 12-14 mm, and the lamination material is high-quality engineering plastic, with extremely high wear resistance. Supported by stainless steel springs, the structure is sturdy. The backwash water flows along the tangential direction of the inner wall of the stack to wash various impurities adhered to the surface of the stack from the inside out. The stack rotates under the action of the backwash water flow, and all impurities are effectively washed and discharged. All steps of backwashing can be controlled using time intervals and pressure differences. Once set up, it can be used for a long time. The automatic backwash filter completes the entire automatic backwash process within seconds without interrupting its operation. The filter using this filtering principle can dynamically change the stack gap during filtration and backwashing, which is very beneficial for improving filtration performance and filtering water quality. It can also greatly reduce the amount of backwashing water used, usually with a self consumption of about 0.25%. The different depths and quantities of grooves on the disc determine the filtering accuracy of the filtering unit.

1. Filtering: Different precision filter laminations can be selected according to water usage requirements, with 20 options available μ、 fifty-five μ、 one hundred μ、 one hundred and thirty μ、 two hundred μ、 four hundred μ Various specifications. 2. Backwashing: High speed and thorough backwashing can be completed in about 7-15 seconds, and the backwashing water consumption is less than 0.5% of the filtered water. 3. Fully automatic operation, continuous water discharge: Within the filter set, the backwashing process alternates between working and backwashing states, ensuring continuous water discharge and minimal system pressure loss. 4. Standard modularization: The standard modular system design allows users to configure according to their needs, making it simple, flexible, and highly interchangeable. 5. Land saving: It can flexibly utilize corner space and install according to local conditions, with minimal land occupation. If the treated water volume is 300 cubic meters per hour, the general water quality is filtered to level 100 μ The equipment covers only 3 square meters. 6. Reliable operation and simple maintenance: almost no daily maintenance is required, installation and operation are convenient, components have been inspected and tested in the factory, no special tools are required, and very few spare parts are required Long service life: The high-tech plastic filter element is sturdy, wear-resistant, and corrosion-free. After years of industrial practical verification, the filtering and backwashing effects will not deteriorate with use time.

Backwash pressure * 1.0bar (using the third generation patented ultra-low pressure backwash technology) System pressure loss 0.08-0.8kg Design flow per unit (M3/Hr) 5 (20 microns), 10 (55 microns), 15 (more than 100 microns) Flow rate per unit 8-10 cubic meters/hour Backwash fluid consumption per unit 17-33 liters Material: NYLON Operating temperature: 70 ℃