Electric forklift 0.5 ton small fully automatic stacking, handling, and loading/unloading four-wheel forklift

1. Maintain an appropriate starting speed during startup and should not be too aggressive.

2. Pay attention to the voltage of the Voltmeter. If it is lower than the limit voltage, the forklift should stop running immediately.

3. During the walking process of a forklift, it is not allowed to change the direction of travel by flipping the direction switch to prevent burning out electrical components and damaging gears.

4. Driving and lifting should not be carried out simultaneously.

5. Pay attention to whether the sound of the drive system and steering system is normal. In case of abnormal sound, remove the fault in time. It is forbidden to operate with fault.

6. Slow down in advance when making changes.

7. When working on poor road conditions, its importance should be appropriately reduced and the driving speed should be reduced.

1. Before lifting, it is necessary to understand the weight of the goods, and the weight of the goods must not exceed the rated lifting capacity of the forklift.

2. When lifting and packaging goods, attention should be paid to whether the packaging is firm.

3. Adjust the spacing between forks according to the size of the goods, so that the goods are evenly distributed between the two forks to avoid partial loading.

4. When inserting goods into the cargo pile, the gantry should tilt forward. After the goods are loaded into the fork, the gantry should tilt back to make the goods close to the fork wall and lower the goods as much as possible

Then you can drive.

5. When lifting or lowering goods, they should generally be carried out in a vertical position.

6. During manual loading and unloading, hand brakes must be used to stabilize the forks.

7. Walking and lifting are not allowed to operate simultaneously.