Sichuan Buried Fire Water Tank BDF Material Yuxuan Production Height 3 meters

Sichuan Buried Fire Water Tank BDF Material Yuxuan Production Height 3 meters

The advantages of underground fire pool water supply equipment are as follows:
1. Underground fire water tank saves space: the water pump and pump room are placed in the water tank and fixed on the module of the integrated pump station. Usually, only 0.5~1.5m of water tank volume is occupied.
2. The underground fire water tank is easy to move and disassemble, and has a long service life. Due to the use of prefabricated stainless steel water tanks, the previous welding method has been changed. It is assembled with screws, which has strong applicability, convenient installation, and does not require * * equipment.
3. The underground fire water tank is easy to evacuate: due to the use of a new type of submersible fire pump, it can be directly submerged in the water without the need for specialized air discharge. As long as the water tank level is within the specified level, it can directly enter the fire water supply state.
4. Buried fire water tank to prevent freezing and cracking: The fire pump is buried deep in the water tank and will not be burned out due to freezing in winter.
5. Buried fire water tank with low noise: equipped with a submerged motor and water pump, greatly reducing operating noise.
6. Reliability of buried fire water tanks: Water immersed motors will not burn out or corrode motor bearings due to rain or environmental temperature.
7. The upgrade of the underground fire pool is simple: there is an interface left to support remote transmission and automatic cleaning.

BDF water tank assembly method
1. Firstly, assemble and assemble the molded plates, and use bolts and sealing rings to seal and connect the plates according to the size of the water tank × wide × High bolt tightening;
2. After assembling several large panels, the bottom plate assembly is carried out. Firstly, the size of the water tank bottom plate is aligned, and then the bottom plate is laid on the water tank foundation for sealing connection. After the bottom plate is connected, fire oil inspection or visual inspection of the sealing area is carried out;
3. After the bottom plate is connected, the wall panel and bottom plate are connected. The bolt connection involves first placing one side of the code on the bottom plate of the water tank. After the four wall codes are installed, adjust the connection by pressing the edges. The relative angle of the compound ruler generally does not exceed 2mm, and it is required to be in a straight line. The four corners require the bottom to be perpendicular to the wall connection;
4. After the bottom of the water tank and the wall are sealed and connected with bolts and sealing rings, the top and wall are connected, and the edges are required to be basically on a horizontal line. The water tank manhole is connected to the * * position according to customer requirements, usually located near the floating ball of the inlet hole;
5. After the connection and sealing of the water tank body are completed, then open inlet, outlet, overflow, sewage, fire holes, and install the rear escalator near the manhole;
6. The internal tie bars of the box are made of stainless steel plates and folded into right angle angle steel and channel steel through a folding machine. The tie bars are connected in a layer from the bottom up 50cm, with a vertical and horizontal spacing of 1m between each layer × 1m, * distance between the two layers * 50cm for the first layer, height and spacing, and so on. The wall is connected to the wall, the wall is connected to the bottom plate, and the wall is connected to the top plate with angle steel;
7. After the completion of various tasks, if water testing conditions are available on site, conduct water injection and pressure testing on the water tank, and check the sealing areas around the water tank for any leakage or water seepage.